Flank Worms of Worm Gear Hob
2022-08-26 15:20:35
jiangxingTools
2485
Flank Worms of Worm Gear Hob
the flank worms of a worm gear hob is determined by the flank form of the driving worm. The various flank forms are standardized in DIN 3975, which distinguishes between ZA, ZN, ZI, and ZK worms, according to the generating method.
Worm gear hobs are shank type worm wheel hobs, bore type worm gear hob, without single start, 2 start, or multi-starts, which can be made in HSS M2, M35, ASP30, ASP52, S390.
相關(guān)文章
-
PA20° DP20 Standard Module Gear Hob with BPⅡ
PA20° DP20 Standard Module Gear Hob with BPⅡdiametral pitch: Dp20, pressure angle: PA20°hob size: OD... - Single Thread Combination Pitch Gear Hobs
- Pre-cutting disc-type gear shaper cutter with DIN 3972/III
- PA20° Profile DIN3972 Standard Gear Hob Cutter with Module m1
- PA20° PCD 240mm β5° Disk Type Conventional Gear Shaving Cutter with Module m2~m8
- PA20° Pre-shaving Gear Hob Cutter with Module m1.75
- PA20° Module m3.25 Standard Involute Gear Hobbing
