Taper Shank Type Shaper Cutters with DIN 1828
2023-03-26 14:07:45
jiangxingTools
2033
Taper Shank Type Shaper Cutters with DIN 1828
These shaper cutters are 20° PA, non-topping finishing cutters for straight spur gears,
tooth profile of shaper cutters is according to DIN 3972 profile Ⅱ，
there is no center hole on cutting face end of shaper cutter.
More taper is No. 2 and No.4 for above shank type shaper cutters.
相關(guān)文章
-
PA20° Module m9 Standard Involute Gear Hob Cutter
PA20° Module m9 Standard Involute Gear Hob CutterTooth profile: DIN3972-2 standard, GBMaterial：HSS M... - PA20° Pre-shave Gear Hobbing with Module m2.25
- PA20° Module m7 Standard Involute Gear Hobbing Cutter
- PA20° Module m1.25 Standard Involute Gear Cutter Hob
- M42, M35, M2 Timing Pulley Hobs with TiN, AP Coating
- Gear Hob for Chain Sprockets to DIN 8196
- Involute Spline Hob with PA45°
